AD301
$69.30 inc GST
Infra Red Interface card for Hospital TV systems
Vayrotec manufacture an interface Card to connect between the Patient’s Nurse Call Handset and the Patient’s TV.
This module provides isolation between the Patient Handset and the TV and allows control of the TV functions from the Patient handset.
The card can be made to operate on 12 or 24 volt Systems and usually draws its operating power from the Nurse Call system. The TV audio is sourced from the TV headphone jack and data is sent to the TV in Coded Infrared format through an IR radiating diode. The diode is usually added to the rear of the TV through a 3mm hole located near the TV IR Receiver. This means the TV does not have to be opened to make wiring connections. The card allows 5 Infrared codes to be sent as follows;
TV ON/OFF
Channel UP
Channel DN
Volume UP
Volume DN
Other codes can be programmed if required.
These cards are fitted with an audio amplifier and a digital volume control chip allowing the low level audio available from the Headphone jack to be comfortable at the Patient Handset speaker. When this method is used the Volume Infrared codes are not transmitted to the TV, but go via the digital volume control on the AD301 module. The Nurse can adjust the maximum volume level using a TV remote and the Patient then has control only up to that level.
In situations where the TV headphone volume is sufficient to operate the patient handset speaker, the audio amplifier and digital volume chip on the control interface module can be bypassed.
Physical
The module has a 4 way screw terminal connector for the IR diode and the TV Audio. Leads fitted with a 3mm IR diode and leads fitted with a 3.5mm audio plug are available. These are cut to length depending on the particular TV and mounting position. The module has an RJ45 header for the Patient handset (wallplate) connections and Power supply. The RJ45 connection details are as shown in the appropriate drawing.
Dimensions are; 87 x 68 x 32 with two mounting flanges extending 10mm. The case is black textured ABS. This case attaches unobtrusively to the back of the TV.